Steering Wheel "Shudder" Is (Still) "Driving" Me Nuts

[Aristides (Aristides Balanos)]

@awg

You can make a toe gauge specific for your car, out of scrap lumber or metal and some screws, placed up against rims, it will be accurate to 1mm, which is within spec

My new Alignment tool

All home made. Screws, nuts, string, two pendulum needles (from windshield wipers), printed scales and some square, U and L shaped bars. The front and rear transverse bars have notches at exactly the same distances, this makes a perfect square. The exhaust tip is quite handy for supporting the rear and the grill for the front. Once left and right sides are equidistant you have two lines exactly parallel to the center drive line of the car. The initial calibration was quite time consuming, b…