Breakers yard, and an IRS

[awg (tony)]

@MLee

Well Plan F went down in a blaze of nothingness.

Is it ONLY the radius arms holding it on?..if so, you may need too make this tool, took me about 1hr.

No radius arm on earth can resist!..one I did would have laughed at a prybar

[E-Type] super easy radius arm removal technique

Faced with stubborn old IRS radius arm mounts, I devised a very simple method to remove them. made a tool out of 1/4’’ x 4’’ scrap steel plate. Angle ground a U shape that exactly matches the INNER STEEL BUSH of the large IRS bush. push the steel plate over the mount,from the front, so it is resting on the bush. This leaves a small space between the chassis leg, and the steel plate tool. gently hammer 2 small cold chisels either side, between tool ‘‘legs’’ and chassis leg. The bush ha…

plate in operation