IRS toe inquiry

[Aristides (Aristides Balanos)]

@mike90

Aristides has given some interesting ideas for home-built kit to make the measurements. Rigorous geometry, is what is needed, but otherwise, seems rather straightforward at least to measure.

Here is some more

My new Alignment tool

All home made. Screws, nuts, string, two pendulum needles (from windshield wipers), printed scales and some square, U and L shaped bars. The front and rear transverse bars have notches at exactly the same distances, this makes a perfect square. The exhaust tip is quite handy for supporting the rear and the grill for the front. Once left and right sides are equidistant you have two lines exactly parallel to the center drive line of the car. The initial calibration was quite time consuming, b…